Safety Precautions - Ribimex Ribiland PRW254A Manuel D'instructions Et D'utilisation

measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and
any other condition that may affect the power tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous situation.
3.1.5) Service
a) Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
b) Have your tool repaired by a qualified person. Any protective guard or other part that is damaged
should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this
instruction manual.
This electric tool complies with the relevant safety rules. Repairs should only be carried out by qualified
persons using original spare parts; otherwise this may result in considerable danger to the user. The use
of unauthorized parts or failure to follow the maintenance instructions may result in injury or damage.
c) Maintain tools with care. Keep cutting tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Keep handles dry, clean and free from oil
and grease.
Note: Unplug power tool when not in use, before servicing and before changing accessories such as
cutting device.

3.2- Safety precautions

3.2.1- Initial preparation before operation
- When you operate the tool, always wear full-length trousers, as well as sturdy, closed footwear that
provide good support. Do NOT operate the tool wearing shorts, when barefoot or wearing open sandals!
- Do not wear loose clothing or jewelry that can be drawn into the moving parts. Keep long hair away
from the moving parts (for ex. put it in a hair net.)
- Wear protective equipment and always wear protective goggles while operating the tool.
Wearing protective equipment such as a dust mask, non-slip footwear, protective gloves, a helmet and
hearing protection (depending on the type and application of the electrical device concerned) reduces the
risk of injury.
- When performing work that generates dust, wear a dust protective mask to prevent dust irritation.
- Each time before you use the tool, check the integrity of the product's power cord and your own
extension cord for signs of damage and ageing. Do not use the tool if the cord is damaged or worn. - The
product should only be operated when its accessories are in perfect working order.
Any damaged or defective components should be repaired immediately by a qualified technician. Never
attempt to use an incomplete, not fully assembled or modified tool.
- Under no circumstances should the tool be operated while safety devices or protective guards or shields
are damaged or if safety equipment such as protective devices is not installed.
- Only use a weather proof extension cable fitted with coupler to IEC 60320-2-3.
Only extension cords that are rated for outdoor use should be used outdoors.
2
Any extension cord used should have a minimum cross section of 1.5mm . All plug-in connections should
have an earth contact and water-spray shielding.
- Browse the working area to:
Page 20 / 45