Stopping The Engine - Shindaiwa AHS2510 Manuel D'utilisation

1. Choke lever
2. Cold Start

Stopping the engine

1. Ignition switch
2. Throttle trigger
3. Run
3. Stop
Engine operation
3. Check that the choke lever is in the "Run" position.
4. If fuel tank is not empty, pull on the starter grip to start the
engine.
5. If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
6. Checking that the area around you is safe and pull on the
starter grip to start the engine.
1. Release the throttle trigger and set the engine to idling (i.e.
low speed).
2. Move the ignition switch to the Stop position.
3. In the event of an emergency, stop the engine immediately
using the ignition switch.
4. If the engine fails to stop, move the choke lever to the "Cold
Start" position. The engine will stall and come to a halt (a
choke stop).
∗ If the engine fails to stop when the ignition switch is used, have
the ignition switch checked and repaired by your dealer before
you use the product again.
Always disconnect the spark plug wire from the spark plug to en-
sure the engine cannot be started before you work on the unit or
leave it unattended.
The cutting attachment can continue moving after the
engine is stopped.
21
WARNING