Humidity And Ultrasonic; Saving Settings; Auto" Operating Mode; Controlling Humidity - Boneco U250 Mode D'emploi

30

HUMIDITY AND ULTRASONIC

en

SAVING SETTINGS

The BONECO U250 saves the last-used settings when
it is switched off. However, if the appliance is dis-
connected from the power outlet for a few seconds,
it will start in the operating mode.

"AUTO" OPERATING MODE

After switching on, the appliance is in
ing mode. The desired relative humidity level (rH) is
pre-set to 50% in operating mode. The appli-
ance selects the suitable performance level Low "L"
/ Medium "M" / High "H" to reach the rH value of 50%
as soon as possible.
In operating mode, the rH can be modified at
any time using the button. If the performance
level is modified using the
operating mode switches off automatically, and the
appliance is in manual operating mode.
To return to operating mode, tap the
bol once.

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In
the "Co" setting (for "Continuous"), the ultrasonic
runs regardless of the measured humidity. This
means it does not switch off until the tank is empty
or the appliance is switched off.
operat-
1. Tap the
starts flashing.
2. While the display is flashing, tap the
again until the desired humidity is set.
The value is applied after a few seconds. The display
stops flashing.
button, the
sym-
symbol. The current humidity display
symbol

CONTROLLING OUTPUT

1. Tap the symbol multiple times until the de-
sired level appears on the display.
The symbol on the display indicates which of the
three levels (low/medium/high) has been selected: