Humidity And Humidifier; Save Settings; Auto" Operating Mode; Controlling Humidity - Boneco U700 Mode D'emploi

30

HUMIDITY AND HUMIDIFIER

en

SAVE SETTINGS

The BONECO U700 saves the last-used settings when
it is switched off. However, if the appliance is dis-
connected from the power supply for a few sec-
onds, it will start in the

"AUTO" OPERATING MODE

After switching on, the appliance is in
ing mode. The desired relative humidity level (rH) is
pre-set to 50% in operating mode. The appli-
ance selects the suitable performance level Low "L"
/ Medium "M" / High "H" to reach the rH value of 50%
as soon as possible.
In operating mode, the rH can be modified at
any time using the button. If the performance
level is modified using the
erating mode switches off automatically, and the
appliance is in manual operating mode.
The heater can be switched on or off without the
appliance exiting operating mode. Operating
mode also remains active
timer.
To return to operating mode, tap the
bol once.

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In
the "Co" setting (for "Continuous"), the humidi-
fier runs regardless of the measured humidity. This
operating mode. means it does not switch off until the tank is empty
or the appliance is switched off.
operat-
1. Tap the
starts flashing.
2. While the indicator is flashing, tap the
again, until the desired humidity is set.
The value is applied after a few seconds. The indica-
tor stops flashing.
button, the op-
when setting the
sym-
symbol. The current humidity indicator
symbol

REGULATE THE OUTPUT

1. Tap the symbol multiple times, until the de-
sired level appears on the display.
The symbol on the display shows which of the three
levels (low/medium/high) has been selected: