Publicité
Les langues disponibles
Les langues disponibles
3.
Mount the backing plate to the heater with screws in the
4 slots (2 per side) of the plate; slide the plate in desired
position according to wall finish. Tighten the screws.
4.
Fix the hanging brackets to the back side of the Inner
Casting as shown. Note the left/right orientation of the
brackets.
5.
There are 4 tabs on the inside of the heater's black
frame; those are intended for mounting other trims.
These tabs conflict with the installation of the cast front
packaged with this kit. These 4 tabs must either be cut off
or bent back out of the way to allow the Inner Casting to
install—see diagram.
6.
Hook the Inner Casting to the edge of the backing plate
flanges as shown.
3
Publicité
