Bare Wire And Pin Connectors; Controls; Volume Up / Down; Banana Connectors - Martin Logan Bravado Manuel De L'utilisateur

speaker's cable is connected with correct polarity:
red (+) to red (+) and black (–) to black (–).

BARE WIRE AND PIN CONNECTORS

If connecting to the Forte amplifier using bare wire
or pin connectors, loosen the binding posts by
unscrewing them to expose the connection hole
in the shaft of the binding post. Insert the speaker
c
ontrols
POWER: Press and release to turn the
product on/off.
Press and hold the power button for 3 seconds to
reboot your wireless product. Press and hold the
power button for 10 seconds to reset your wireless
product to factory settings and clear the network
configuration.
Your wireless product will enter Standby Mode
(reduced power consumption) after 20 minutes
of no music playing. It will automatically wake-up
when it senses music being received. The Power
button will stay illuminated whether the unit is pow-
ered on or in Standby Mode. If there is a power
failure while your wireless product is switched on, it
will switch back on once power has been restored.

VOLUME UP / DOWN:

Press once to turn volume up/
down. Press and hold to ramp the volume up/down.
MUTE: Press and release to mute the
MartinLogan wireless product. Pressing this
button a second time or pressing either volume button
will restore the previous volume setting. If you are using
ARC™ (Anthem Room Correction) press and hold the
mute button for 5 seconds to turn off ARC on/off. A
'negative tone' will sound to verify ARC is switched off.
A 'positive tone' will sound to verify ARC is switched on.
12
wire or pin into the hole and retighten the binding
post.
BANANA PLUG CONNECTORS
If you are connecting the Forte amplifier using
banana plugs, remove the end caps from the Forte
amplifier's binding posts to expose the banana
plug socket; insert the banana plug into the socket.
INPUT: Switches to the rear panel analog
input. This button illuminates white when
streaming mode is enabled and blue when
the analog input is enabled. If the wireless product is
set to analog input and detects a new audio stream,
it will automatically switch to streaming mode.
WI-FI INDICATOR: The Wi-Fi Indicator tells you
what your wireless product is doing.
• Rapid Blinking: booting up.
• Blinking: connecting to a wireless router.
• Slow Pulse: Access Point Setup Mode.
• Two Blinks & Pause: WPS (Wi-Fi Protected
Setup) Mode.
• Solid: Connected to a wireless router.
• Off: Connected to a router via Ethernet.
FIXED VOLUME MODE: When fixed level is
on, the output volume level of the unit is set to a
fixed level for sources connected to the analog in-
put. To enable fixed volume mode hold the volume
down and mute buttons for five seconds. Hold them
again for five seconds to cancel.
AUTO AUX INPUT MODE: These devices can
be configured to automatically select the Auxiliary
input when DTS Play-Fi is turned off. This mode can
be useful when using the device to improve TV audio.