Product Description - Bosch FCA-500-EU Guide D'installation

FCA-500-EU | FCA-500-E-EU

Product Description

See Figure 1, Page 3 to Figure 3, Page 3.
Position Description
1 Holders for cable ties
2 Lettering for conventional
connection
3 Long slit
4 Triangular mark
5 Single guideway
*By default, a spring for mounting the detector in concrete and wooden
ceilings is preinstalled (identifiable by the red marking.) For mounting a
detector in a false ceiling panel you can use the additional, softer spring in
the package. In this use case, the detector must not be subjected to strong
vibrations (> 350 m/s). The shock resistance according to EN 54-7, Section
5.13 is not warranted then.
Connection
See Figure 1, Page 3 to Figure 3, Page 3.
Wire the base according to the lettering for GLT connection (2). During
cabling, the holders for cable ties (1) can be used to fix the base.
Connection
Voltage + (2 terminals)*
Voltage -
Trouble relay
Alarm relay
Shielding
Indicator output
* Terminals for looping through the power supply.
** The wire can be re-feeded from the trouble relay by connecting it to
terminal t .
o
End-of-line Resistor: See Figure 1, Page 3. For the last base on the stub line
(FCA-500-E-EU), place the EOL resistor between the two screw clamps (7).
Alarm Resistor: See Figure 1, Page 3. By breaking off the printed circuit
board tongue, the alarm contact resistance is changed from 0 Ω to 680 Ω
(8).
Bosch Sicherheitssysteme GmbH
Position Description
Terminal
+V
0V
t (not connected)**
o
t (C)
1
t (NC)
2
b1/b2 (NO)
a1/a2 (C)
c
6 Spring*
7 End-of-line resistor
8 Printed circuit board
tongue
MPA External Detector Alarm
Display (MPA)
4-Wire
black (bk)
-
green (gn),
to b1/b2
yellow (ye)
yellow (ye)
white (wh)
blue (bu)
F.01U.002.683 | 4.0 | 2011.09
en
6-Wire
red (rd)
[green (gn)]
brown (bn)
brown (bn)
6