Maintenance And Cleaning - Montiss CSC620 Mode D'emploi

Filling the water tank
Remove the water tank from the main body, open the water tank cup anticlockwise, fill the water
tank from the tap and close. Install the water tank back onto the main body (D) until it clicks into
place.
Operation
Plug the steam mop into the mains power supply. When it turns on the indicator light will turn red to
show that it is heating up.
The steam mop will take approximately 30 seconds to warm up. Once it has reached the correct
temperature, the indicator light will change blue. The steam mop is now ready to use.

MAINTENANCE AND CLEANING

Ensure that no water penetrates the device. Never submerge it in water or any other liquid.
Do not turn on the steam mop during use.
Cleaning the device
1. Take the plug from the socket before you start cleaning the device. Always allow the device to
cool down properly before you start cleaning it.
2. Take the microfiber cleaning pad from the device. The microfiber cleaning pad is washable.
3. Clean the non-electrical parts of the steam mop in warm soapy water and dry thoroughly. Wipe it
clean with a soft, dry cloth. Do not use harsh or abrasive cleaners or detergents
Attention: Never immerse the electrical components in water or any other liquid.
Please note: This steam mop is not suitable for dishwasher use
Cleaning the microfiber cleaning pad
The micro fiber cleaning pad can be washed at 40° (do not use bleach or fabric softener, do not
tumble dry!). Leave the microfiber cleaning pad to dry for 24 hours.
Remove Limescale
If the steam mop begins to produce steam slower than usual or stops producing steam completely,
you may need to remove limescale. Limescale can develop over time on the metal parts and greatly
affects performance. It is necessary to remove limescale on a regular basis, every 25-50 times you
use a full tank of water or at least once a month, especially in areas with hard water.
To remove the limescale:
1. Prepare a solution of white vinegar and tap water and add it to the water tank.
2. Secure and position the steam mop to ensure that the steam released is aimed away from the
floor or surrounding objects and surfaces
3. Plug the steam mop into the mains power supply and turn it on. Allow it to produce steam until
all of the solution is used
4. Repeat the above procedure as often as necessary, then fill the tank with fresh water
5. Fill the tank to the maximum level with fresh water, switch it on and release steam until the
water tank is empty
If there is a blockage in the steam nozzle, use the cleaning needle to clean the blockage along with
the descaling solution. Insert the cleaning needle into the steam nozzle hole
to clear the blockage.
Warning: Be sure that the steam mop is switched off and has cooled fully.
After using the cleaning needle, add the descaling solution to the tank and
follow the steps to remove limescale.
23