Remove Follower Plate And Pump - FLUX VISCOFLUX lite Manuel D'instructions Original

6.2

Remove follower plate and pump

Attention!
> The follower plate has to be taken off the drum after every drum
 On emptied drums the follower plate sticks to the bottom.
> Switch the pump off, if not already done.
Do not yet disassemble the pump!
> Release the union nut for the motor fixing on
the pump and take off the motor.
> Do not take off flange-mounted three-phase
motors.
> Connect the compressed air supply on the
threaded nipple.
> Switch on the compressed air supply. To do
so, slowly open the ball valve (1) on the
pressurising and venting hose. Allow
compressed air to flow into the drum slowly.
The follower plate will move upwards.
> When lifting the follower plate press down
the pump (see picture). Then the pump is not
pushed out of the follower plate guidance
and there is no premature demolition of
compressed air.
> The follower plate moves upwards. It can
come to stand at the height of the bottom
drum bead.
> Hook the arresting hook (2) on the edge of
the drum so that the follower plate does not
fall back on the bottom of the drum.
> Switch off the compressed air only then.
 On drums with smooth edges, see page 34.
emptying!
Operating instructions VISCOFLUX lite
1
33 / 60