Wiring Of The Power 48-5000 - Torqeedo Power 48-5000 Traduction De La Notice D'emploi Originale

DE EN FR
Installation using M8 threaded bushes
1. Place the Power 48-5000 on a suitable mounting location.
2. Fasten the Power 48-5000 from underneath, using the M8 threaded bushes
(depth 9 mm) (2).
3. Check that the Power 48-5000 is fitted tightly.
Installation using a strap
1. Place the Power 48-5000 on the intended location.
2. Fix the Power 48-5000 in place using four straps that are guided through the
elongated slots (1) provided.
Do not fasten the straps over the lid.
3. Check that the Power 48-5000 is fitted tightly.
Installation using M6 threaded rods
1. Place the Power 48-5000 on the intended location.
2. Guide the M6 threaded rods through the attachment points (1) with washers (18
mm, for example 3D washer as per DIN 9021).
3. Screw the M6 threaded rods into the hull of the boat, and fit washers (for large
washers = 18 mm, tighten to max. 7 Nm, for small washers = 12 mm, tighten to
max 2.5 Nm).
4. Check that the Power 48-5000 is fitted tightly.
page 48 / 104
ADVI C E
5.3

Wiring of the Power 48-5000

WARNIN G!
Danger of injury from short circuit.
This can result in severe physical injuries or death.
Remove metal jewellery and wristwatches before you start work on batteries
or in their vicinity.
Always put down tools and metal objects without making contact with the
battery.
When connecting the battery, ensure correct polarity and secure connec-
tions.
Battery terminals must be clean and free of corrosion.
Do not store batteries hazardously in a box or drawer, e.g. an insufficiently
ventilated locker.
CA UTION!
Damage to the battery or other electrical loads from a short circuit.
Material damage can result.
When working on the batteries, always switch the system off at the main
switch.
De-energise the Power 48-5000 and do not connect a data cable.
When connecting the batteries, ensure that you first connect the red positive
cable followed by the black negative cable.
Note the tightening torques (positive terminal 17 Nm and negative terminal
30 Nm).
When disconnecting the batteries, ensure that you first disconnect the black
negative cable followed by the red positive cable.
Never transpose the polarities.
AD VICE
Do not lead the cables over sharp edges, and cover all open terminal caps.
Start-up