Table des Matières
Publicité
Inspect the door annually and adjust and lubricate as
necessary. Follow the manufacturer's instructions.
Note on greasing:
Grease the rails as well as the bolts in the roller (34/35) during
assembly and be sure to regrease them once a year.
Grease the rail on which the slide and the driver ring glide and
be sure to regrease once a year.
9. Note for service personnel:
When in doubt, the control circuit board and the hand transmitter
should also be sent when electronic or electrical components are
inspected at the service center.
10. Important safety instructions
CAUTION - In order to prevent serious or fatal injuries:
It is vitally important to observe all the instructions; non-
observance may have fatal consequences.
Keep the remote control where unauthorized persons,
endangered persons and children cannot use it to operate the
door opener. Similarly, you should take steps to ensure that
the door coding unit and the inside switch cannot be operated
by the groups of persons mentioned above.
Read and follow all instructions.
Never let children operate the door controls or be allowed to
play with them. Keep the remote control out of the reach of
children.
Always keep the door opener in full view and ensure that no
persons or objects are in the direct vicinity. Do not let persons
or animals cross the path of the moving door.
Monthly checks: The following checks have to be carried out
every month:
- Check that the garage door opener performs all its
functions. The garage door must return after striking a
50 mm high object on the ground.
- Check that any additionally installed accessories (e.g.
a light barrier) perform their various functions.
- Check that all screw the connections are tight.
- Check for signs of wear, defects or insufficient balance
of the garage door and the garage door opener (e.g.
springs, fasteners, cables).
If possible, use the emergency release only when the door is
closed. Exercise caution when using the release with an
opened door. Weak or broken springs can result in the door
suddenly dropping, which can lead to serious or fatal injuries.
Ensure that the garage door is properly balanced - refer to the
manufacturer's handbook. An incorrectly aligned door can lead
to serious or fatal injuries. Permit only trained maintenance
personnel to perform repair work on the cables, spring sets
and other assembly components.
High torques may arise at certain points, e.g. where the door
pivots, in spite of an electronic force limitation feature. It is
essential, therefore, to follow the door's movement with great
attention in order to prevent serious accidents, particularly
where children are concerned.
Keep these instructions for future reference
11. Important mounting instructions
CAUTION - In order to prevent serious or fatal injuries:
1. Read and follow all instructions.
2. Only mount the door opener on a properly aligned garage
door. An incorrectly aligned door could lead to serious
injuries. Permit only trained maintenance personnel to
perform repair work on the cables, spring sets and other
assembly components of the system responsible for
maintaining balance prior to mounting the opening
mechanism.
3. Before you fit the opening mechanism remove or deactivate
all cables and locking devices except those which are
operated by the opening mechanism to be connected to the
garage door.
4. If possible, mount the door opener 2.1 meters or higher above
the ground and the emergency release 1.8 meters above the
ground.
5. When mounting a garage door control button, ensure that it is
a) located close to the door, (b) at a minimal height of 1.5
meters so that small children cannot reach it and (c) located
away from all moving door parts.
6. After assembling the opening mechanism, the door must
return after striking a 50 mm high object placed on the floor.
7. When you have completed the installation work, make sure
that no parts of the door project into public paths or roads.
8. When you have completed the installation work, make sure
that the drive prevents or interrupts the opening movement
when the door is loaded with a weight of 20 kg fastened to the
center of the bottom edge of the door (for drives that can be
used with a door having openings in the door panel with a
diameter greater than 50 mm).
6. Fonctions
Ouverture et fermeture par impulsion signal à l'aide
d'une émetteur manuel, d'un bouton-poussoir intérieur, d'un
bouton-poussoir à clé ou d'une serrure codée. (voir
accessoires)
Protection du code d'émission contre les manipulations
(protection de balayage), protège contre l'ouverture non
autorisée de la porte de garage.
Si la porte bute sur un obstacle lors de l'ouverture ou de la
fermeture, elle s'immobilise et déleste la porte.
L'impulsion suivante la fait repartir dans le sens opposé.
La porte peut être immobilisée dans chaque position
intermédiaire par une impulsion.
L'impulsion suivant l'arrêt intermédiaire fait repartir la
porte dans le sens opposé.
La porte est maintenue fermée par le mécanisme à blocage
automatique.
Tous les blocages côté porte doivent être retirés !
Une sécurité complémen taire est assurée par le kit
d'enclenchement pour portes (voir accessoires)
La porte peut être déverrouillée par le système de
déverrouillage d'urgence et être ensuite commandée
manuellement.
L'éclairage intégré s'allume grâce à un impulsion
d'actionnement, pour une durée - de 2,5 mn.
7. Remarques importantes
Respecter inconditionnellement les instructions de
montage et de service.
Veuillez respecter scrupuleusement le point 15
„Mise en service"
Le système de commande de porte de garage TA 70 est
exclusivement réservé à l'emploi privé! Toute autre
application ne correspond pas à l'affectation.
Les connexions électriques doivent être effectuées par
un électricien (non comprisdans le service après-vente).
Débrancher la fiche secteur en cas de : démontage du
capot, travaux au niveau du câble d'entraînement.
Utiliser des ampoules jusqu'à 25 W max.
N'actionner l'automatisme d'ouverture que si: la vue
sur la porte du garage est dégagée, si l'axe de pivotement est
dégagé.
Ne rentrez et ne sortez du garage que lorsque la porte du
garage est entièrement ouverte.
Veiller à la propreté de la butée de porte au sol
(neige, glace, pierres, etc.)
Si, en cas de basses températures, la sécurité d'obstacles
ne devait pas se déclencher, en raison de l'inertie du
matériau, il faut alors recommencer l'apprentissage des
13
Publicité
Table des Matières
