Installed Rivet Nut Is Loose - Degometal GO 3312 Instructions De Sécurité Et Mode D'emploi

Damage because the traction power is too high or
the working stroke is too long
Indicator 9 (GO3312 fig.A) blinks and stays on
9.3

Installed rivet nut is loose

Cause
Traction power is too low
Released before reaching the set stroke
Traction power (see point 4.2) or the working stoke
Special warning: battery must be removed before
adjusting, otherwise it will cause personal injury.
Use a hex driver to unscrew (refer to point5.2 and
5.3.2; refer to illustrations 1,2,3,4)
Have the tool checked and serviced by qualified
1 – Rotate anticlockwise carefully to loosen rear cover 8.
2 – Expose the hexagonal hole at the rear end of the tool.
3 – Insert the hex screwdriver SW5 enclosed into the hexagonal
hole, rotate anticlockwise carefully to loosen, unscrew and
replace the rivet nut.
4 – If necessary, use the enclosed double head nut wrench SW
16/21 to rotate the hex screw driver, so as to unscrew
the rivet nut in an easier way.
Troubleshooting
Set traction power properly (refer to key point 4.2)
Set working stroke properly (refer to key point 4.3)
www.degometal.com
(see point 4.3)
personnel
36