Clarke CombiVac 12 Manuel De L'opérateur page 18

1
Figure 11
5
5
Figure 12
Page 18
2
4
3
1
2
5. Install the tool holder on the handle tube. To
install the tool holder, follow this procedure:
a. Put the tool holder in position around the
handle tube.
b. Put the crevice tool in the tool holder (1).
See figure 11.
c. Put the cable holder into the hole of the
handle (2). See figure 11.
6. Put the wand adapter in the larger end of the
wand.
7. Put the hose adapter into the opening in the back
of the tank housing (1). See figure 12.
8. Put the end of the wand in the back of the tank
housing (2). See figure 12.
9. Push the wand assembly forward until it locks in
position (3). See figure 12.
10. Put the vacuum hose over the hook on the handle
assembly (4). See figure 12.
11. Put the power cord around the cord storage
hooks (5). See figure 12.
®
Clarke CombiVac 12 & 14 Operator's Manual