Calibration ( Only Available To Authorised Personnel) - Baxtran SML Mode D'emploi

F5 SL Auto standby
Select the time of auto standby
SLP 0
SLP 1
SLP 2
SLP 3
SLP 4
F6 Gv Gravity ( parameter blocked by the calibration switch)
Introduce the gravity of destination if it is different from the calibration one.
Using the key
your operation by pressing the key
F7 Ci Nuevo password
Introduce the new password to acces to the paremeters.
Using the key
your operation by pressing the key
F8 CL CALIBRATION (parameter blocked by the calibration switch)

7. CALIBRATION ( ONLY AVAILABLE TO AUTHORISED PERSONNEL)

The calibration must be done only by authorised technical personnel. Please, if you want to do a calibration contact
with your calibration authorised organism to seal and unseal the scale. When the equipment has been verified, the
breaking of the seal implies the loss of the verification.
Access the settings menu F8, following the procedure described in the previous section.
Press once the internal key of calibration.
Access the parameter using the key
The equipment is going to ask for a password ( 000 by default), using the key
the key T the user can increase the blinking digit.
 
Confirm using the key
The message "UnLD" is going to appear in the display.
Download the weighing hook and wait until the LED diode which indicates stability switches on.
Press the key It will appear the calibration mass correctly adjusted.
To proceed to do a change, choose the digit to modify by using the key
which is blinking it the active digit.
Without automatic standby

It is going to activate the standby mode after 5 minutes without any load.

It is going to activate the standby mode after 10 minutes without any load.

It is going to activate the standby mode after 20 minutes without any load.

It is going to activate the standby mode after 30 minutes without any load.

choose the digits of edition, using the key
.
choose the digits of edition, using the key
.
USER'S MANUAL SML
you can increase the blinking digit. Confirm
you can increase the blinking digit. Confirm
the user can choose the digits of edition and using
and change its value by using the key
EN
The digit
.
23