WAGNER POWERPAINTER 90 EXTRA SKID Mode D'emploi page 35

PowerPainter 90 EXTRA Skid
incorrect assembly and/or commissioning by the buyer or by a third party, or utilisation other than is intended, abnormal ambient
conditions, unsuitable coating materials, unsuitable operating conditions, operation with the incorrect mains voltage supply/
frequency, over-operation or defective servicing or care and/or cleaning.
-
for errors in the device that have been caused by using accessory parts, additional components or spare parts that are not original
Wagner parts.
-
for products to which modifications or additions have been carried out.
-
for products where the serial number has been removed or is illegible
-
for products to which attempts at repairs have been carried out by unauthorised persons.
-
for products with slight deviations from the target properties, which are negligible with regard to the value and usability of the device.
-
for products that have been partially or fully taken apart.
5. Additional regulations.
The above guarantees apply exclusively to products that have been bought by authorised specialist shops in the EU, CIS, Australia
and are used within the reference country.
If the check shows that the case is not a guarantee case, repairs are carried out at the expense of the buyer.
The above regulations manage the legal relationship to us concludingly. Additional claims, in particular for damages and losses of
any type, which occur as a result of the product or its use, are excluded from the product liability act except with regard to the area
of application.
Claims for liability for defects to the specialist trader remain unaffected.
German law applies to this guarantee. The contractual language is German. In the event that the meaning of the German and a
foreign text of this guarantee deviate from one another, the meaning of the German text has priority.
J. Wagner GmbH
Division Professional Finishing
Otto Lilienthal Strasse 18
88677 Markdorf
Federal Republic of Germany
Warning
If the supply cord of this appliance is damaged, it must only be replaced
by a repair shop appointed by the manufacturer, because special purpose
tools are required.
The wires in this mains lead are coloured in accordance with the following
code:
green/yellow = earth
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifiying the terminals in your
plug, proceed as follows:
•
The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol or coloured green or green and yellow.
•
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
•
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured brown.
•
Should the moulded plug have to be replaced, never re-use the defective plug or attempt to plug it into a different 13 A socket.
This could result in an electric shock.
•
Should it be necessary to exchange the fuse in the plug only use fuses approved by ASTA in accordance with BS 1362. Only 13
Amp fuses may be used.
•
To ensure that the fuse and fuse carrier are correctly mounted please observe the provided markings or colour coding in the
plug.
•
After changing the fuse, always make sure that the fuse carrier is correctly inserted. With out the fuse carrier, it is not permissible
to use the plug.
•
The correct fuses and fuse carriers are available from your local electrical supplies stockist.
blue = neutral
brown = live
GB
Subject to modifications
29