Configuring The Speed Controller; Important; Inserting Batteries/Rechargeable Batteries Into The Remote Control; Configuring The Remote Control - Reely 4WD RtR Notice D'emploi

b) Configuring the speed controller
The speed controller features two jumpers that can be
used to configure the driving functions and the recharge-
able battery.
"Reverse" jumper (A): Here reverse driving can be turned
off ("Disable") or on ("Enable").
"Battery" jumper (B): Set here which drive battery is con-
nected to the speed controller (LiPo or NiMH drive bat-
tery).

Important!

If you are using a LiPo drive rechargeable
battery and set the battery type to NiMH, the
battery will overdischarge and be permanently
damaged.
Always ensure that you select the correct bat-
tery type before driving the vehicle.
The "LiPo" setting reduces the engine power by 50%
when the battery voltage drops below 6.5 V.
With a battery voltage below 6.0 V, the speed controller switches off the engine. In this way, the LiPo battery is pro-
tected from harmful deep discharge.
The "NiMH" setting reduces the engine power when the battery voltage drops below 4.5 V. The engine is switched off
when the battery voltage drops below 4.0 V.
c) Inserting batteries/rechargeable batteries into the remote control
Open the battery compartment on the remote control and insert new or fully charged batteries. Ensure that the
batteries are inserted in the correct polarity (observe the positive/+ and negative/- markings). Replace the battery
compartment cover.
Read the remote control instructions included with the product.
d) Configuring the remote control
Switch on the remote control and set the steering and throttle trim to the central position. If the remote control has a
dual rate feature, disable it or adjust it so that the steering angle is not limited.
Read the remote control instructions included with the product.
40