Setup; Removing The Chassis; Configuring The Speed Controller; Important - Reely « Free Men » RtR Notice D'emploi

9. Setup

a) Removing the chassis
Remove the clips and lift the chassis off the vehicle.
b) Configuring the speed controller
The speed controller features two jumpers that can be
used to configure the driving functions and the recharge-
able battery.
"MODE" jumper (A): Use this jumper to select the operat-
ing mode. Leave the jumper in the "Crawler" setting.
"BATT" jumper (B): Use this jumper to select which type
of battery is connected to the speed controller (LiPo or
NiMH).

Important!

If you are using a LiPo vehicle battery and set
the battery type to NiMH, the battery will over-
discharge and be permanently damaged.
Always ensure that you select the correct bat-
tery type before driving the vehicle.
The "LiPo" setting reduces the motor power by 50 % when
the battery voltage drops below 6.5 V.
The speed controller switches the motor off when the bat-
tery voltage drops below 6.0 V. This prevents the LiPo
battery from overdischarging, which damages the battery.
The "NiMH" setting reduces the motor power when the
battery voltage drops below 4.5 V. The motor is switched
off when the battery voltage drops below 4.0 V.
c) Inserting batteries into the remote control
Open the battery compartment on the remote control and insert new or fully charged batteries. Ensure that the
batteries are inserted in the correct polarity (observe the positive/+ and negative/- markings). Replace the battery
compartment cover.
Read the remote control instructions included with the product.
35