Setup; Open/Remove The Body - Reely 4WD RtR Notice D'emploi

9. Setup

a) Open/remove the body
The body can be folded up to engage the drive battery or for adjustments to the speed control. For this purpose, there
is a special quick lock at the rear of the vehicle.
Do not over-tighten the quick-lock. Do not use force when opening and closing.
Open the body
• Press and hold the round knob (A) in the middle of the
quick lock and turn the outer handle (B) 90° counter-
clockwise (to the left).
• Release the button.
• The body can then be folded upwards.
Close the body
• Fold the body upwards.
• Press and hold the round knob (A) in the middle of the
quick lock and turn the outer handle (B) 90° clockwise
(to the right).
• Release the button.
Set the locking bolt
If the quick lock does not open or close properly, check
that the locking latch (C) has released inside or is twisted.
The locking bolt (C) must be oriented so that it is at a 90°
angle to the handle (B). Only then can the quick lock be
released and closed.
Disassemble the body
The articulation between the vehicle and the body can be
very easily removed by unscrewing two screws (D) on the
front of the vehicle (one screw each on the left and right).
39