Inside Structure - L.B. White Foreman CI230 Manuel Du Propriétaire Et Instructions

10
Foreman Ductable Oil Indirect-Fired Heater

Inside Structure

WARNING
Asphyxiation Hazard
■ When installing indoors the heater's exhaust
must be vented to the outside.
■ Failure to comply can result in asphyxiation
due to lack of adequate air supply or carbon
monoxide poisoning.
■ Carbon monoxide poisoning can lead to seri-
ous injury or death.
IN EXISTING CHIMNEY
1) Anti-wind device, optional accessory
2) Horizontal crossing with minimal upside angle pitch of 5°
3) Chimney 8 in. x 8 in. of minimal inside measure
4) Chimney anti-explosion flap door
5) External seating wall
Note: The above information is a recommendation only.
Have you installation checked by a local authority.
Outside Structure
To prevent recirculation of flue gas from the exhaust
outlet to the heater air inlet, an exhaust stack of
5ft./1.25meter minimum is required to be installed
onto the exhaust outlet. To protect against water en-
try when the heater is installed outdoors, a rain cap
is necessary. Optional accessory may be purchased
through the L. B. White Co. Rain cap or chimney.
Owner's Manual • Foreman
WARNING
Asphyxiation Hazard
■ When this heater is connected to a flue pipe,
the flue pipe shall terminate in a vertical sec-
tion at least two feet long and sufficient draft
shall be created to assure safe and proper
operation of the heater. A minimum draft of
0.20 in. w.c. is recommended.
■ Where back drafts may occur a vent cap
should be used on the exit from the flue pipe.
■ Horizontal runs of flue pipe should have a rise
of 1 in 10 away from the heater.
DIRECTLY TO OUTSIDE
1
A. Minimal 3 Ft.
B. Minimal 3 ft.
C. Shortest
D. The same or bigger than the
heaters stack outlet diameter.
E. Minimal 3 ft.
Rain Cap
Chimney
Exhaust Outlet