Videotec MAXIMUS MBX Manuel D'instructions page 8

CAUTION!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
• Make sure the appliance is securely anchored
before supplying power.
• Any change that is not expressly approved by the
manufacturer will invalidate the guarantee.
• For technical services, consult only and exclusively
authorized technicians.
• Comply with all the national standards during the
device installation.
• The product can be installed in any position.
• All disconnected wires must be electrically
isolated.
• The manufacturer declines all liability for damage
to any of the apparatus mentioned in this
handbook, when resulting from tampering, use of
non-original spare parts, installation, maintenance
and repairs performed by non-authorised, non-
skilled personnel.
• This product must only be repaired by suitably
trained personnel or under the supervision of
VIDEOTEC personnel in accordance with the
foreseen terms and conditions: IEC/EN60079-19.
• For damage to any parts, repair or replacement
must be done by, or under supervision of
VIDEOTEC.
• Whenever replacing the parts as indicated,
always use VIDEOTEC original spare parts and
meticulously follow the maintenance instructions
supplied with every spare parts kit.
• Use adequate personal protective equipment
during installation.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook. Improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
6
• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or other
hazards.
• Connect the device to a power source
corresponding to the indications given on the
marking label. Before proceeding with installation
make sure that the power line is properly isolated.
INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
• For handling there are no particular instructions.
It is recommended, to assigned staff, to carry out
operation observing the common rules of accident
prevention.
• Make sure that all precautions for personal safety
have been taken.
• Before proceeding with installation, check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels (4.2 Product marking, page 9).
• Equipment intended for installation in Restricted
Access Location performed by specialist technical
staff.
• Since the user is responsible for choosing the
surface to which the unit is to be anchored, we
do not supply the fixing devices for attaching the
unit firmly to the particular surface. The installer is
responsible for choosing fixing devices suitable for
the specific purpose on hand. Use methods and
materials capable of supporting at least 4 times the
weight of the device. Remember to use screws no
less than M8 (ISO261) or equivalent.
MNVCMBXSW_2222_EN