About This Manual; Typographical Conventions; Notes On Copyright And Information On Trademarks; Safety Rules - Videotec MAXIMUS MBX Manuel D'instructions

1 About this manual

Read all the documentation supplied carefully before
installing and using this unit. Keep this manual
and use instructions of the box within reach for
subsequent consultation.

1.1 Typographical conventions

DANGER!
Explosion hazard.
Read carefully to avoid danger of explosion.
DANGER!
High level hazard.
Risk of electric shock. Disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
CAUTION!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
2 Notes on copyright and
information on trademarks
The mentioned names of products or companies are
trademarks or registered trademarks.
MNVCMBXSW_2222_EN

3 Safety rules

Read the product Manual A before
performing any operation.
DANGER!
High level hazard.
Risk of electric shock. Disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
• Before starting any operation, make sure the
power supply is disconnected.
• A power disconnect device must be included
in the electrical installation, and it must be very
quickly recognizable and operated if needed.
• Be careful not to use cables that seem worn or old.
• The electrical system to which the unit is
connected must be equipped with a 16A max
automatic bipolar circuit breaker. The minimum
distance between the circuit breaker contacts
must be 3mm (0.1in). The circuit breaker must
be provided with protection against the fault
current towards the ground (differential) and the
overcurrent (magnetothermal).
• This equipment is not suitable for use in locations
where children are likely to be present.
• All the cables must comply with IEC60332-1-2, IEC
60332-1-3 and IEC/EN60079-14.
5