Troubleshooting - A&D Medical LIFESOURCE 1100 ULTRACONNECT Mode D'emploi

TROUBLESHOOTING

Symptom
Cause
Power
does not
turn on.
The cuff
does not
inflate.
The device
does not
measure.
Readings
are too
high or too
low.
Other
Note: If the actions described above do not solve the problem, contact the dealer.
Do not attempt to open or repair this product, as any attempt to do so will make
your warranty invalid.
E-28
Probable
Low Battery
Blood Pressure
monitor internal
error.
Battery charging
cable is connected.
Low Battery
You moved your
wrist or body during
measurement.
––––
The cuff position is
not correct.
The value is
different from that
measured at a clinic
or doctor's office.
Treatment
Charge the battery.
Press the Reset Switch.
Remove the charging cable.
Charge the battery.
Make sure you remain still and
quiet during measurement.
If you have a very weak or
irregular heartbeat, the device
may have difficulty in determining
your blood pressure.
Sit comfortably and still. Place
your arm on a table with your palm
facing upward and the wrist cuff at
the same level as your heart.
At a clinic or doctor's office
apprehension may cause
an elevated reading. Home
measurement reduces the effects
of outside influences on blood
pressure readings, supplementing
the doctor's readings.