Emerson DESIGNER CF755GRT06 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.9
The Fan comes with Blue, Black and White Wires that
are 80" long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 3.5" Downrod Assembly (Figure 9).
Cut off excess Wires and strip back Insulation 1/2-inch
from end of Wires.
3.10
Carefully turn the Partially Assembled Ceiling Fan over
and place it on the Styrofoam for Final Preparation
(Figure 10).
Remove the Shipping Spacers and the Spacer
Attachment Screws from the Motor Hub before
installation of Blade Assemblies (Figure 10).
Discard the Spacers and Spacer Screws.
(Continued)
6 to 9
INCHES
HANGER BALL
Figure 9
Figure 10
8
1/2
INCH
SPACER ATTACHMENT
SCREWS (4)
SHIPPING SPACERS (4)
MOTOR
HUB
U.L. Model No.: CF755