Emerson DESIGNER CF755GRT06 Mode D'emploi page 11

3. Ceiling Fan Assembly
3.14
Mount the Blade Flange to the Fan Blade using Three
M5 x 6 mm Washer Head Screws and three Blade
Washers (supplied) (Figure 14).
Repeat this procedure for other four Fan Blades and
Blade Flanges.
WARNING
!
To reduce the risk of personal injury, do not bend
the blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
A spare M5 x 6 mm Washer Head Screw and Blade
Washer are supplied in parts bag, if needed.
3.15
NOTE: Take care not to scratch fan housing when
installing blades.
Attach one Blade Assembly to the Motor Hub using
Two M6 x 14 mm Captive Screws with Lockwashers in
Flange.
Make sure the Screws are NOT tightened. (Figure 15).
Repeat this procedure for the other Four Blade
Assemblies.
NOTE: The blade flanges have an interlocking
feature that must be fully engaged before
tightening the screws. Make sure all the flanges
are properly engaged and then tighten the flange
screws. If one of the flanges does not seat properly
on the motor hub, loosen the adjacent flange
screws, re-engage and reseat the flanges, then
tighten the screws again.
A spare M6 x 14 mm Captive Screw with Lockwasher is
supplied in parts bag, if needed.
(Continued)
M5 x 6 mm WASHER HEAD
BLADE SCREW (3)
BLADE WASHER (3)
BLADE FLANGE
Figure 14
M6 x 14 mm
CAPTIVE SCREWS
WITH LOCKWASHERS
Figure 15
Please contact 1-800-654-3545 for further assistance
11
FAN BLADE
BLADE
ASSEMBLY
emersonfans.com
U.L. Model No.: CF755