Lcd Settings; Code Description - Tripp-Lite SmartOnline SVT Serie Manuel Du Propriétaire

4. Operation

4.7 LCD Settings

There are three parameters to set up the UPS. Refer to the illustration below.
Parameter 1 is for program alternatives. Refer to below tables for the programs to set up.
Parameter 2 and Parameter 3 are the setting options or values for each program.
Note: Use the "Up" or "Down" button to change the programs or parameters.
Programs Available for Parameter 1:

Code Description

Output voltage
01
Output frequency
02
03 Voltage range for bypass
04 Frequency range for bypass
ECO mode enable/disable
05
Voltage range for ECO mode
06
07 Frequency range for ECO mode
08 Bypass mode setting
09 Maximum battery discharge time setting
Reserved
10
11 Reserved
12 Neutral loss detection
13 Battery voltage calibration
Charger voltage adjustment
14
Inverter A voltage adjustment
15
16 Inverter B voltage adjustment
17 Inverter C voltage adjustment
Output A voltage calibration
18
Output B voltage calibration
19
20 Output C voltage calibration
A  in chart indicates the program can be set in the mode listed.
Note: All parameter settings will be saved only when the UPS shuts down normally with internal or external battery connection. (Normal UPS shutdown
means turning off input breaker in Bypass/Standby mode).
Bypass /
Standby mode AC mode







 
 
Reserved for future options
Reserved for future options
 
 
 






17
Freq.
ECO Converter Battery
mode mode mode
 
 
 
 






Battery
Test
 
 
 
 





