Emergency Power Down Box; Pair Remote - Ergomotion Serta Motion CUSTOM Manuel Du Propriétaire

emergency power down box

In the event that the base is stuck in an articulated position during a power outage- the
Power Down Box will return the base to a flat position.
(2) 9 Volt batteries are required to operate the power down feature and are NOT included.
STEP 1
Locate the Power Down Box under the base.
During the first few minutes of the power outage, the button on
the box will blink red so that it is easy to locate.
14
STEP 2
Press and hold the button until the base is flat.
Note: The red light will turn off after several minutes, however the
button can be pressed at any time during the loss of power to
bring the base flat.
For emergency use only.
The Power Down Box can only be used to bring the base to a
flat position. It will not bring the base to a flat position when
the base is connected to a working power source.

pair remote

The original remote that comes in the box is already paired to the bed base.
No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote
control. Remove and replace
batteries.
STEP 2
Double click the button on the
Power Down Box (this will not
cause the base to move). The
light will illuminate.
If the Power Down Box is not available- Press Reset button on control box. Pairing LED light on control box will begin to blink. Press and
hold button on the back of the remote, the button will begin to blink. Both lights will become continuous and then simultaneously turn off.
STEP 3
Press and hold button on the back of the remote.
The light will begin to flash then become a
continuous solid light.
STEP 4
Both lights on the Power Down Box and the
Remote will be continuous, then simultaneously
turn off. Replace back cover of the remote.
The remote is now paired with the base.
15