Media Faceplate (Usb And Audio); Bluetooth Audio Setup - Ergomotion Serta Motion CUSTOM Manuel Du Propriétaire

media faceplate
USB CHARGERS
USB charging connections are
located on each side of the base.
Charge two smart devices at the
same time. The green LED light will
illuminate when the faceplate is
receiving power.
AUDIO INPUT
An audio input connection is
located next to the USB chargers
on the base. Use an auxiliary cable
to connect any MP3 player to the
speakers located under the base.
10 10
MAGNETIC REMOTE HOLDER
Read and remove warning sticker located on top of the magnet
before attaching the remote to the base.
NOTE: This product contains Neodymium MAGNETS which
may interfere with devices such as pacemakers, ICD's and
any other device sensitive to magnetic fields. It is STRONGLY
recommended that owners of such medical devices consult their
physician prior to using this product.
bluetooth audio setup
®
Connect any smart device with Bluetooth
STEP 1
Ensure that the Audio Power Cord attached to the sound system
is plugged into a power source (surge protector is recommended).
STEP 2
Locate Bluetooth settings on the smart device. Select the
®
Bluetooth code that begins with "SERTA SOUND-XXXXXX"
®
STEP 3
Once connected, use any music player on the smart device to
wirelessly stream music.
Use the device to control volume level. To further customize
volume levels, see OPTIONAL section below.
OPTIONAL
To adjust master volume level:
Speakers default to medium, use the volume + and - buttons
located on the small speakers underneath the head portion of the
platform. Use remote to lift the head portion of the base to access
the speakers. (See photo above).
To switch devices:
Turn off Bluetooth ® on active device OR select the active device in
your Bluetooth ® settings and press "forget this device". You may
now pair another device.
capability to wirelessly stream music.
®
For assistance setting up a Bluetooth® connection or operating music
player, refer to your smart device's owners manual or contact the
manufacturer directly.
To switch between Bluetooth and Auxiliary Input:
®
Use the remote to lift the head portion of the base to access the
speakers. Press the SYNC button located on the small speakers
under the head portion of the base. (See photo above).
To sync two audio systems (TL or CKS):
See page 16
11 11