Bluetooth Remote Control Setup; Headboard Bracket Installation Guide - Ergomotion Serta Motion CUSTOM Manuel Du Propriétaire

bluetooth remote control setup

To operate the base from a smart device, the Serta Remote application must be downloaded to the
desired smart device from the App Store (Apple) or Google Play Store (Android).
STEP 1
Unplug the base from power source (a surge protector is
recommended). Wait 30 seconds and plug back in.
STEP 2
The BT CONNECTION LED on the control box will blink blue
for 2 minutes. During this time the base is discoverable by any
Bluetooth compatible device.
®
STEP 3
Locate Bluetooth ® settings on your smart device. Select the device
that begins with SERTA-iXXXXXXXX. The blue light on the control
box will stop blinking and will remain illuminated as long as a
Bluetooth ® connection is established.
Note: This ID number matches the number listed on the control box.
For assistance setting up a Bluetooth ® connection, refer
to your smart device's owners manual or contact the
manufacturer directly.
12
STEP 4
Open the SERTA application on your device and select your
SERTA-i ID number (if not automatically prompted, select the
"Settings" button within the app).
The remote on the application may be used to operate the base.
See Remote Overview (pg 8-9) for remote operating instructions.

headboard bracket installation guide

A 9/16" & 1/2" socket and crescent wrench are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which the
leg threads. Hold the bracket in place and screw the leg into the
base until it is snug. DO NOT OVERTIGHTEN. Too much force
may cause the leg to spin freely.
b) Align the tab with the hole in the frame (located towards the foot
of the base) and use a short bolt and nut to secure the bracket.
Make sure the bolt is tight.
STEP 2
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b.) To install the plastic spacer and attachment plate, you will need
(2) long bolts and (2) nuts. Place the spacer and attachment
plate in the desired location and slip the bolts through the holes
with the head of the bolt facing outward. Position the bolts
diagonally on the spacer. Use the 9/16" socket and wrench to
tighten the bolts.
STEP 3
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets. The heads of the bolts will face outward. Use a 9/16"
socket and 1/2" wrench to tighten the bolts.
13