Reinstall Grease Filter(S) - Broan Elite EW48 Serie Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11. INSTALL THE DECORATIVE FLUE (
N
-
:
oN
DucteD INstallatIoN
Slide up the upper flue until it is aligned with the plenum. Secure the upper flue to the
plenum using 2 M4 x 12 Phillips 9 mm round head screws.
Remove protective plastic film covering the upper flue and the hood.
D
:
ucteD INstallatIoN
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must be
inside the flue. Secure the upper flue to its bracket using 2 M4 x 12 Phillips 9 mm round
head screws.
NOTE: Duct not shown in illustration to ease understanding.
Remove protective plastic film covering the upper flue and the hood.

12. REINSTALL GREASE FILTER(S)

N
-
:
oN
DucteD INstallatIoN
Install a charcoal filter on each aluminum grease filter back (A). Hold the
charcoal filter in place by inserting both ends of the 3 metal strips in each
aluminum grease filter frame (B).
a
:
ll INstallatIoNs
To reinstall the grease filters, align rear filter tabs with slots in the hood. Pull
down the metal latch tab, push each filter into position and release. Make
sure filters are securely engaged after installation.
)
continued
A
HA0145
HD1149
9
HO0293
u
pper Flue mouNtINg bracket
F
roNt vIew
u
pper
Flue
HO0292
B

Publicité

Chapitres

Table des Matières
loading

Table des Matières