Table Des Matières; Prepare Installation; Select Installation Type - Broan Elite EW48 Serie Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
(
-
ducted installation only
(
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

1. PREPARE INSTALLATION

NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the retailer.
Make sure that the following items are included:
- Hood
- Hood mounting bracket
- Decorative flue assembly (lower and upper flues)
- Upper flue mounting bracket
- Aluminum grease filter(s) (1 for 24-in. width hood, 2 for 30-in. and
36-in. width hoods)
- Installation instructions
- Parts bag: 9 no. 8 x 11/2" Phillips flat head screws,
2 M4 x 12 Phillips 9 mm round head screws,
2 washers and 3 wire connectors.
Parts sold separately:
- Ducts, elbows, wall and roof caps.
- Optional flue extension for ceilings of 9 ft. or more: models AEEW48SS
(stainless steel), AEEW48BLS (black stainless steel) or AEEW48WH (white).
- Non-duct kit model ARKEW48, mandatory for non-ducted installation.
NOTE: During installation, protect countertop and/or cooktop.

2. SELECT INSTALLATION TYPE

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
2.1 N
-D
I
oN
ucteD
NstallatIoN
The ARKEW48 non-duct kit is required for a non-ducted installation.
2.2 D
I
ucteD
NstallatIoN
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few
of them as possible. Larger ducting may be required for longer duct runs.
Install wall or roof cap. Connect 6" round metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints.
2.3 a
I
ll
NstallatIoNs
The minimum hood distance above cooktop is 24" . A maximum of 30" above
cooktop is recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
NOTE: Ceilings of 9 ft. or more require flue extension model AEEW48SS (stainless
steel), AEEW48BLS (black stainless steel) or AEEW48WH (white).
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . 3
(
ducted installation only
) . . . . . . . . . 4
) . . . . . . . . . . . . . . . . . . . . . . . . . 5
) 4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
WARNING
! !
VQ0010
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
. . . . . . . . . . . . . . . . . . . . . . 8
. . . . . . . . . . . . . . . . . . . . . 8-9
(
) . . . . . . . . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
(1
(9) #8
FLAT HEAD SCREWS
(2) M4
(1) D
ECORATIVE FLUE
ROUND HEAD SCREWS
ASSEMBLY
(2) W
(3) W
(1) H
OOD MOUNTING
BRACKET
HR0269A
R
OOF CAP
D
ECORATIVE
FLUE
H
OOD
24"
MINIMUM ABOVE
COOKING SURFACE
HH0281A
(1) U
PPER FLUE
MOUNTING BRACKET
2) G
(
)
OR
REASE FILTER
S
1-1/2" P
X
HILLIPS
12 P
X
HILLIPS
ASHERS
IRE CONNECTORS
6" R
OUND
DUCT
W
ALL
CAP
6" R
OUND
ELBOW

Publicité

Chapitres

Table des Matières
loading

Table des Matières