Reinstall Grease Filters - Broan Elite EW46 Série Manuel D'installation, D'utilisation Et D'entretien

12. INSTALL THE DECORATIVE FLUE (
N - :
ON DUCTED INSTALLATION
Slide up the upper flue until it is aligned with the plenum. Secure the upper flue to the
plenum using 2 M4 x12 Phillips 9 mm round head screws.
Remove protective plastic film covering the upper flue and the hood.
D :
UCTED INSTALLATION
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must
be inside the flue. Secure the upper flue to its bracket using 2 M4 x12 Phillips 9 mm
round head screws.
NOTE: Duct not shown in illustration to ease understanding.
Remove protective plastic film covering the upper flue and the hood.

13. REINSTALL GREASE FILTERS

N - :
ON DUCTED INSTALLATION
Install a charcoal filter on each aluminum grease filter back (A). Hold the
charcoal filter in place by inserting both ends of the 3 metal strips in each
aluminum grease filter frame (B).
A :
LL INSTALLATIONS
To reinstall the grease filters, align rear filter tabs with slots in the hood.
Pull down the metal latch tab, push each filter into position and release.
Make sure filters are securely engaged after installation.
)
CONTINUED
A
HA0145
HD1149
9
HO0293
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
U
PPER
FLUE
HO0299
B