Safety Features - EUROM HP1404 Livret D'instructions

STORAGE

Before clearing the machine away, the water must be removed from the pump, the hose and the
accessories. You do this by switching the machine off with the switch and disconnecting the water
supply hose. Now start the machine again and squeeze the handle. Allow the machine to operate
until no more water comes out of the jet lance. Then switch the machine off immediately. Never allow
it to 'run dry'!

Remove the plug from the socket, wind the cable up and hang it on the hook.

Place the handle and the lances in the holders on the machine.

Roll up the hose and secure the bundle in the handle.

The machine must be stored frost-free. If this is impossible, have the machine suck in anti-freeze
before you store it. Remember to flush the machine thoroughly with water before using it again! If the
machine nevertheless freezes, have it checked before use. Frost damage is not covered by the
guarantee. Never start a frozen high-pressure cleaner!

SAFETY FEATURES

The nozzle is fitted with a 'lock' for safety. If you push the switch away, the handle is locked and will not
function. Unlock the handle by pushing this switch back to the original position.
The motor is fitted with a thermal safety feature that switches it off when it overheats. In principle, it will
start again automatically when it is sufficiently cooled. But it is better to switch the machine off for 5 to 10
minutes, wait, and then start it again. Identify the cause of the overheating and remove it. If this problem
recurs, stop using the machine and contact your supplier / repair service.
MAINTENANCE
Attention: Always take the plug out of the socket before you execute maintenance!

Flush the water supply hose, the high-pressure hose, the jet lance, the nozzle and other accessories
thoroughly before you use them.

Carefully remove dust, sand or other dirt from the connections.
For all other cleaning work: make it as often as necessary. If the item is heavily soiled, you're too late!
Then encrease the frequency

Regularly clean the nozzle with the pin supplied and then flush it
thoroughly (against the direction of the jet). To do this you must remove
the nozzle from the lance.

Regularly clean the filter in the water inlet. To do this, unscrew the water inlet connector, remove the
filter with a screwdriver or similar tool and check that it is undamaged. Fasten everything firmly and
correctly in the appropriate place. Never use the cleaner without a filter!

Keep the ventilation openings of the machine clean in order to prevent obstruction of the cooling
function.

Regularly grease the O-rings of the connectors in order to prevent them from drying out.

Repairs and inspections must only be carried out by your supplier or appropriately trained and
authorised persons. Inexpertly executed repairs will nullify the guarantee. Never carry out repairs
by yourself!
Service address: Euromac bv., Kokosstraat 20, 8281JC Genemuiden-NL
Tel. (0031)(0)38-3854321
REMOVAL
In the EU this symbol indicates that this product may be disposed of as ordinary
household waste. Old equipment contains valuable materials, suitable for recycling. These
materials should be made suitable for reuse in order to prevent any adverse effects to
health and the environment caused by unregulated waste collection. Therefore, please
make sure that you bring old equipment to a designated collection point. Alternatively,
contact the original supplier, who can make sure that as many of the components as
possible can be recycled.
21
Fax: (0031)(0)38-3856464 Email: info@euromac.nl