Rotating The Display; Features - Tripp-Lite PDU3VSR6H50A Manuel Du Propriétaire

i
Using the Digital Display

Rotating the Display

0 3.0
0 i

Features

C13
Outlet Status LED
Push-to-Reset Guard
13-09-017-9332B8.indb 16
Outlets: During normal operation, the outlets
distribute AC power to connected equipment.
C19
Outlet Status LED: Once the unit is powered on, each outlet individually
ramps up and each Outlet Status LED will illuminate when the associated
outlet is ready to distribute live AC power.
LED Color Outlet Status
Green On
Yellow On
Red Off
Flashing Red Off
Off Off
Note: Colors noted here reflect standard LED configuration. See chart on page 15
for full LED color definitions.
Circuit Breaker: There are 6 Load Banks, each protected by a circuit
breaker. If the connected equipment load exceeds the Maximum Load
Rating for that bank of the PDU, the circuit breaker will trip. Disconnect
excess load and reset the breaker.
Note: Each breaker comes equipped with a push-to-reset guard to prevent
accidental breaker tripping. To turn off the breaker, insert a flathead screwdriver into
the reset slot.
Mounting Brackets: Use these brackets to mount the PDU.
Mounting Buttons: Come pre-installed on the back side of the PDU and
are used for toolless mounting. Note: Four additional mounting buttons
are included for alternate rack styles.
At any point, pressing both of the arrow
buttons simultaneously and holding
for 3 seconds rotates the 2-digit and
3-digit displays.
Comments/Notes
Normal operation.
Outlet current has exceeded 80% of the outlet
current rating.
Outlet voltage is below the Low Voltage threshold.
Circuit breaker for this bank has tripped.
Outlet is powered off.
16
9/5/2013 4:26:58 PM