Installation; Mounting The Pdu - Tripp-Lite PDUMNH15 Manuel Du Propriétaire

2. Features
1U 2U
A
Link LED Color
A
Off
Flashing Amber
Flashing Green

3. Installation

3.1 Mounting the PDU

The PDU supports five primary mounting
configurations: 1U Rack, 2U Rack, 0U Rack,
Wall and Under-Counter.
Note: Regardless of configuration, the user must determine the
fitness of hardware and procedures before mounting. The PDU
and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all applications.
Exact mounting configurations may vary.
1
1U Rack Mounting: Attach the PDU to the
rack by inserting four user-supplied screws
through the PDU mounting brackets
the mounting holes of the rack rail as shown.
201006064 93-3049.indb 4
( continued )
Mounting Brackets: These detachable brackets enable the PDU to be
installed in a rackmount configuration or an under-counter configuration.
Ground Connection: Use this to connect any equipment that requires a
chassis ground.
SNMP Card Ports:
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity
monitoring and a dry contact interface to control and monitor alarm,
security and telecom devices. Contact Tripp Lite Customer Support at
www.tripplite.com for ordering information. Note: Do not connect a
keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program. A serial
cable (part number 73-1025) is included with the PDU. If you need to
order a replacement cable, contact Tripp Lite Customer Support at
www.tripplite.com.
Ethernet Port: Use this RJ-45 jack to connect the PDU to the network
with a standard Ethernet patch cable. The Link LED
indicate several operating conditions, as shown in the table below.
B
This port is not compatible with PoE (Power Over Ethernet)
applications.
B
Network Operating Conditions
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
A
and into
B
Status LED Color
B
Off Card Not Initialized
Steady Green Card Initialized and Operational
Flashing Amber Error - Card Not Initialized
1
4
and Status LED
A
B
A
10/6/2010 4:48:41 PM