Installation; Mounting The Pdu - Tripp-Lite PDUMNH15 Manuel De L'utilisateur

2. Features
1U 2U
RESET
STATUS CONFIG

3. Installation

3.1 Mounting the PDU

The PDU supports five primary mounting configurations: 1U Rack, 2U Rack, 0U Rack, Wall and Under-
Counter.
Note: Regardless of configuration, the user must determine the fitness of hardware and procedures before mounting. The PDU and included
hardware are designed for common rack and rack enclosure types and may not be appropriate for all applications. Exact mounting
configurations may vary.
1 1U Rack Mounting: Attach the PDU to the
rack by inserting four user-supplied screws
through the PDU mounting brackets
the mounting holes of the rack rail as shown.
2
2U Rack Mounting (PDUMNH30): Attach
the included brackets to the sides of the PDU
(STEP ) with the included screws. After
2A
installing the brackets, position the PDU in the
rack and install four user-supplied screws through
the unit's brackets (STEP
rails as shown.
16-11-160-933685.indb 4
( continued )
Mounting Brackets: These detachable brackets enable the PDU to be
installed in a rackmount configuration or an under-counter configuration.
Ground Connection: Use this to connect any equipment that requires a
chassis ground.
WEBCARDLX: Allows you to operate this PDU as a managed network
device, accessible via SNMP network management platform, web
browser, SSH or Telnet.
A
and into
B
) and into the rack
2B
1
2A
2B
4
B
A
1/4/2017 2:15:04 PM