Remote Control Operation; Power Source - SOUNDMASTER SCD8000 Manuel D'instruction

REMOTE CONTROL OPERATION

To operate the unit with the remote control, point the remote control at the
remote sensor on the front panel and press the appropriate button on the
remote control. The remote control works best within a range of 6 ~ 7 meters
from the front panel and at an angle of 30 degrees. Bright sunlight or room light
conditions can interfere with the remote control. If the remote operation is
unsatisfactory or stops working entirely, first try replacing the remote batteries,
then try reducing the room lighting conditions.
LITHIUM BATTERY INSTALLATION OF REMOTE CONTROL
• The remote control includes one CR2025 (3V) lithium battery.
• To replace the battery, gently push the clasp to the right direction accordingly to
the instruction and then pull out the battery compartment.
Take the drained battery out and install a new lithium battery (CR-2025) in the
compartment with the positive polarity upward. Then push the compartment back
to its position with a "click" sound indicating the installation is finished.

POWER SOURCE

This unit is designed to be operated on AC/DC power.
AC OPERATION
Plug the AC power cable into the AC socket on unit and then plug into a household AC outlet.
The battery power will automatically be disconnected.
DC OPERATION
Open the BATTERY COMPARTMENT DOOR. Install 10pcs UM-1/D size batteries (not included)
into the compartment. Please follow the correct polarities as indicated.
CAUTION:
• Remove batteries if they are flat or not being used for a long period of time.
• Batteries contain chemical substances, so they should be disposed of properly.
BASIC FUNCTION
TURNING THE UNIT ON/OFF
Press the STANDBY button on the unit or remote control to turn the unit on or off.
NOTE: In CD/MP3/USB/Bluetooth/Aux in mode, when the unit is not providing the main function
for 15 minutes, the unit will automatically switch into standby mode. To turn on the unit again,
press the STANDBY button.
Please note that a low volume setting in the audio source may be recognized as a "no audio
signal", this will affect the capability of signal detection from the device and can also
automatically switch the unit into standby mode. If this happens please reactivate the audio
signal transmission or increase the volume setting on the audio source player in order to
resume playback.
Electrostatic Discharge hints – The unit may reset or may not reset to normal operation mode
due to electrostatic discharge, just switch it off and reconnect it again.
SETTING THE FUNCTION MODE
3
M_SCD8000 / English Instruction Manual