NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
Batteries can leak and lose battery acid. When not using the system for a long period of time, remove the
batteries.
Different battery types or new and used batteries must not be used together.
Do not dispose of batteries with household waste. Return old batteries to the respective collection facilities
or your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of explosion!
NOTE:
After about 10 minute without a signal, the device will automatically switch to "OFF" mode.
GENERAL OPERATION
- At standby mode, press the "STANDBY/FUNCTION" button to switch on the unit.
- Press the "STANDBY/FUNCTION" button once to switch other mode. (CD/ MP3/ USB/ FM/TAPE)
- Press the "VOL+" or "VOL-" button to adjust volume level.
- Press and hold the "STANDBY/FUNCTION" button for 2 seconds to switch off the unit in all modes.
AUTOMATIC TUNING
1. Press the "FUNCTION" button to select "FM" mode.
2. Press and hold the "SKIP+ ►►" or "SKIP- ▌◄◄" button over 2 seconds to start automatic tuning
process.
3. When a station is tuned in the tuning process, it will stop automatically and you can listen to your desired
station.
MANUAL TUNING
It is for selecting stations, which cannot be tuned automatically. (manual selection)
1. Press the "FUNCTION" button to select FM mode.
2. Press the "SKIP+ ►►" or "SKIP- ▌◄◄" button to select station.
3. Each time the "SKIP+ ►►" or "SKIP- ▌◄◄" button is pressed momentarily the frequency changes by a
fixed step: 0.05MHz.
AUTO SCAN
This product equipped auto station scan & saving function. Up to 30 stations can be saved.
1. Press the "FUNCTION" button to select FM mode.
2. Press and hold the "SCAN" button 2 seconds, unit will auto search and save all available radio station.
3. Press the "M+" or "M-" to select your preset station.
PRESET STATION
Up to 30 stations can be presented (replace the AUTO SCAN saving station)
1. Select desired radio station by "SKIP+ ►►" or "SKIP- ▌◄◄".
2. Press the "MEMO" button, the display will show "P01" and flashing.
3. Press the "M+" or "M-" button to select the preset station position.
4. Press the "MEMO" button again to confirm desired radio station in memory.
5. Once all the stations were preset, press the "M+" or "M-" button to listen to your desired station.
FOR BETTER RECEPTION
This appliance has a FM antenna located at the rear cabinet. This wire is completely unraveled and extended for
better reception.
Note: Microphone cannot operate in radio mode.
BASIC FUNKTION
RADIO OPERATION
SCD5750 / English Instruction Manual
2