Prophete REX BIKE CITY Serie Notice D'utilisation page 75

FOLDING STEM
FOLDING IN THE HANDLEBARS
1. Undo the wing screw
stem.
2. Swivel the handlebar stem to the side.
FOLDING OUT THE HANDLEBARS
1. Fold the handlebar stem onto the steer tube. Make
sure that the clamp piece
the designated recess (see Fig. J).
2. Tighten the wing screw
ALIGNING THE HANDLEBARS
1. Fold down the handlebars as described in the Fol-
ding the handlebars chapter
2. Undo the now visible hexagon head screw
with a 6-mm Allen wrench. The screw only needs to be
undone slightly.
3. Set the handlebars on the steer tube and adjust the
position as desired.
4. Fold down the handlebars as described in the chapter
'Folding in the handlebars'.
5. Now tighten the hexagon head screw
(see Torque specifications chapter).
6. Fold down the handlebars as described in the chapter
'Folding out the handlebars'.
ADJUSTING THE HANDLEBAR ANGLE
1. First undo the clamping block screws
handlebar attachment with a 5-mm Allen wrench.
2. Adjust the incline angle of the handlebars.
3. Retighten the clamping block screws
(see chapter Torque specification).
4. Turn the handlebar attachment parts (e.g. brake lever)
back to their initial positions.
(ALU)
(Fig. J) on the handlebar
2
(Fig. J) is positioned in
1
(Fig. J) firmly.
2
(Fig. L) firmly
1
(Fig. L) of the
1
(Fig. L) firmly
1
J
K
(Fig. K)
1
L
HANDLEBAR
1 2
1
1
1
EN 13