Technical Specifications - HQ Power HQRL Série Mode D'emploi

6.5 Shaping the Rope Light
1. Switch off the mains power before you continue.
2. The maximum length of the rope light assembly is 45 m.
Exceeding the maximum length may cause overheating and fire.
3. The bending radius of the rope light is at least 30 cm, do not make sharp bends.
Use connectors to make sharp angles.
Bending radius r = min. 30 cm
4. Bend the rope light according to the pictures on page 2.
7. Installing
1. When you have shaped the rope light, test it again as described above.
2. If the shaped rope light works correctly, you can proceed with mounting. Keep the
light plugged in to warm up the plastic. This makes it more pliable when installing.
3. Switch off the mains power before you actually install the rope light.
8. Use
Check the rope light before every use. Always refer to the safety instructions above.
9.

Technical Specifications

9.1 LED Rope Lights
LED rope lights – common specifications
power supply
LEDs/m
LED space
IP index
diameter
power cord length
LED rope lights – 45 m – common specifications
cutting distance
LED rope lights – 45 m – individual specifications
product code
HQRL45001
HQRL45002
HQRL45003
HQRL45004
HQRL45005
HQRL45006
HQRL45007
V. 02 – 22/10/2018
HQRLxxxxx
colour
cold white
warm white
red
green
blue
yellow
pink
7
230 V~, 50 Hz
36
2.78 cm
IP44
Ø 13 mm
1.5 m
1 m
power consumption
2.2 W/m
2.2 W/m
1.5 W/m
2.2 W/m
2.2 W/m
1.5 W/m
2.2 W/m
©Velleman nv