English Description; Introduction; Warning; Installation - Studer AJ Série Manuel D'utilisation Et De Montage

STUDER Innotec

Introduction

The sine wave inverters of the AJ series
have been designed to meet industrial and
domestic needs. They meet the highest
requirements of comfort,
reliability.
Any device designed
electrical network of 230 V 50 Hz can be
connected to them (up to the nominal
power of the inverter).
The AJ series is the perfect source of
voltage in any place where the public
network is not available.
This document is an essential part of the
inverter and must always be carried with it
and be at the disposition of anyone
working on the installation.
Should you have any doubt or question, do
not hesitate to contact your specialist
salesperson who will give you the best
advice.

Warning

A deficient assembly could result in
damage to the device, cause function
failures or potential damage to the users.
The working device generates a high
voltage which might be lethal in case of
contact. So, any manipulation of the
inverter must be carried out with utmost
care.
THE OWNER MUST NOT MANIPULATE
ANY PIECE INSIDE THE INVERTER.
Opening the inverter or using it incorrectly
will result in the immediate loss of the
warranty.
No current or tension generating device
(public grid, generator,...) may be con-

English description

safety and
for the public
AJ V2.3
nected to the outlet of the inverter
because this could
destruction.
The inverter AJ is to be used only with a
lead battery. As for the use of batteries,
follow the manufacturer's instructions.

Installation

The AJ sine wave inverter is an
electronic device, for
caution must be taken when installing it:
Place where the inverter is to be
installed:
Out of reach of unauthorised persons,
specially children.
In a dry place (max. 95% humidity), and
in any case with no condensation.
Not directly on top of the batteries.
Ventilation must be free, and a space of
10 cm. on each side is needed for good
evacuation of the internal heat.
No easily inflammable material should
be placed directly underneath or close to
the AJ
Fitting the inverter
The inverter is fitted on a non flammable
surface by screws (max. 4mm for AJ
275-AJ 1300 or max. 8mm for AJ 2100
and 2400) using the four holes provided.
The fitting screws are not supplied with
the inverter. It may be fit into any
position.
AJ
result in its
which some
3/30