Troubleshooting - Thermador Star Sapphire Serie Manuel D'utilisation

Troubleshooting

Dishwashers may occasionally exhibit problems that are
unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher
problem without involving a repair professional.
Note: If the appliance stops during dishwashing or does
not start for any obvious reason, first run the cancel wash
cycle function (Reset).
WARNING
9
IMPROPER REPAIRS OR USE OF NON-ORIGINAL
REPLACEMENT PARTS MAY CAUSE
Fault
Error code : is lit.
" ‚‰
Error code : is lit.
" ‹ˆ
Error code : is lit.
" ‚ƒ
Error code : is lit.
" ƒƒ
Error code : is lit.
" ƒ...
Error code : is lit.
" Ġ
Error code : is lit.
" ƒˆ
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked.
Intake opening (on right inside of
appliance) covered by dishes.
Heating element calcified or soiled. Clean appliance with dishwasher cleaning
Filters are soiled or blocked.
1b
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the drain pump loose.
Drain pump blocked or cover on the
drain pump is not locked in posi-
tion.
Mains voltage too low.
CONSIDERABLE DAMAGE AND PUT THE USER
AT CONSIDERABLE RISK
Always have repairs carried out by authorized
technicians. If a component has to be replaced,
always use original replacement parts.
Error message
Some faults are indicated at the top of the display
window and on the front display *
@
remedies are offered (for example Filter system soiled
(E22) -->Clean filters).
* optional feature which may or may not be included with
your dishwasher.
Fault table
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min. when water
supply is open.
Switch off the appliance and pull out the mains
plug. Turn off the tap. Unscrew water connec-
tion.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks. Recon-
nect power supply. Switch on the appliance.
Arrange dishes so that the intake opening is
not obstructed.
agent or descaler. Operate the dishwasher
with water softening system and check the set-
ting.
Clean filters.
Install hose without kinks, remove any residue.
Check connection to siphon and open if
required.
Lock cover correctly.
Clean pump and lock cover correctly.
Not an appliance fault, have the mains voltage
and electrical installation checked.
and possible
):
33