Fault
Food soils on the dishes.
Dishwasher seems to run a
long time
Detergent residue.
Water stains on plastic parts. Droplet formation on plastic sur-
Cause
Dishes placed too closely together,
racks overfilled.
Spray arm rotation obstructed.
Spray arm nozzles are blocked.
Filters
dirty.
1b
Filters
1b
inserted incorrectly and/
or not engaged.
Rinse wash cycle too weak.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Tall narrow containers in corner
areas are not rinsed adequately.
Upper rack
on right and left
12
not set to same height.
Incoming water is not warm enough. Before starting a cycle, run hot water faucet at
Cycle time can vary due to soil and
water conditions.
Rinse aid dispenser
9*
Dishwasher connected to cold
water supply.
Note: : Check the typical wash cycle
length.
Detergent dispenser cover
blocked by dishes and therefore
does not open fully.
Detergent dispenser cover
blocked by the detergent tab.
Detergent tab used in the quick or
short wash cycle.
Dissolving time of the detergent is
not reached in the selected short
wash cycle.
Washing effect and dissolving per-
formance are reduced after a pro-
longed storage time or detergent is
very lumpy.
face is physically unavoidable. After
drying, water stains are visible.
Remedial action
Arrange dishes with adequate clearance
between them ensuring that the spray jets can
reach the surface of the dishes. Prevent con-
tact points.
Arrange dishes so that the spray arm can
rotate without obstruction.
Clean the spray arm nozzles.
Clean filters.
Insert and engage filters correctly.
Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or Inten-
sive.
Do not place hollow containers too obliquely
and do not place in the corner area.
Set upper rack to same height using side
levers.
the sink closest to the dishwasher.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good wash
when heavy soil is detected.
Add rinse aid.
is empty.
Verify dishwasher is connected to hot water
supply plumbing.
Dishes must not be placed above the deter-
92
gent tab tray
the detergent dispenser and prevent it from
opening fully.
Do not place dishes or fragrance dispenser in
the detergent tab tray.
Detergent tab must be inserted flat and not
92
upright.
Dissolving time of detergent tab too long for a
quick or short wash cycle.
Use a detergent powder or select a more
intensive wash cycle.
Change detergent.
Use a more intensive wash cycle (more water
changes).
Arrange dishes in a sloping position.
Use rinse aid.
If required, increase softening setting.
. These may block the lid of
1B
35