A&D Medical LifeSource 1200 ULTRACONNECT Manuel D'utilisation page 20

MEASUREMENT
Visitor Mode Measurement
1. Press the Start button on the monitor.
2. Press the Start button again to switch between
usernames and select "0 Visitor".
3. Measurement starts automatically after 3 seconds.
4. When the measurement is complete, the
monitor will display results similar to the
icon on the right.
pulse rate will scroll.)
Visitor Mode is only available through the monitor. Data is
not stored in visitor mode.
Tips for a Good Measurement
• Sit down in a comfortable position. Place the arm to be used
for the measurement on a table or other support so that the
center of the cuff will be at the same height as your heart.
• Relax for several moments before measurement.
• Remove constricting clothing and place cuff on bare arm.
• Unless your physician recommends otherwise, use left arm
to measure pressure.
• Do not talk during measurement.
• Do not measure immediately after physical exercise or a bath.
Do not smoke or ingest caffeine at least 30 minutes prior to
measurement.
• The automatic blood pressure monitor's performance may be
affected by excessive temperature or humidity, or altitude.
E-20
(Systolic, diastolic and