B) ANTENNA CONNECTOR (SO-239)
C) ACCESSORY CONNECTOR:
- When using the internal speaker only, insert the plug with a short wire
between pins 1 and 7.
- Between pins 1 and 2, an external speaker can be connected.
- Pins 4 and 8 allow to link a PA-speaker.
- Pins 8 and 9 serve to connect morse key.
- Pins 3, 5 and 6 are not used.
1
4
7
See wiring diagram on page 41
2
3
5
6
8
9
C) TECHNICAL CHARACTERISTICS:
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Maximum audio power
- Squelch sensitivity
- Freq. image rejection rate
- Drain
30
: 170
: AM/FM/SSB/CW
: from 26 MHz to 29.7
: 50 ohms
: 13.2 V
: 185 (B) x 250 (H) x 60 (T)
: ca 2,0 kg
: microphone UP/DOWN with support,
mounting cradle, screwsand
fused power cord.
: +/- 300 Hz
: 10 Watts AM/FM/CW
: 21 Watts SSB
: inferior to -50 dBc
: 300 Hz - 3 kHz AM/FM/SSB
: 0,6 mV
: 4,5 A (with modulation)
: 2.5%
: 0.5 µV - 113 dBm (AM/FM)
0.4 µV - 115 dBm (SSB)
: 300 Hz to 3 kHz in AM/FM/SSB
: 4 W
: mini 0.5 µV - maxi 1 mV
: 70 dB
: 1 A nomimal