Cooling & Carbonisation Unit Display - Blanco drink.soda EVOL-S Pro Mode D'emploi

Operation
Cooling & carbonisation unit display
You will only get optimal
sparkling water at 4°C to 5°C.
The higher the temperature, the
less sparkling your soda water
will be!
Not available at
the moment
Normal operating mode with
remaining capacity for CO₂ and
filter displayed (in %). The left-hand
figure shows the remaining capacity
of the filter. The right-hand figure
shows the remaining capacity of
the CO₂ cylinder.
After confirming with 'OK', the
current temperature is displayed
and can be set between 4°C and
10°C using the arrow buttons.
Please note: the appliance takes a
little time to reach the set tempera-
ture.
After confirming with 'OK', the
appliance displays the connectivity
mode for connecting with an app:
"CON OFF" = connectivity module
inactive; "CON ON" = connectivity
module active. Use the arrow buttons
to change the mode and confirm by
pressing 'OK'.
To reset to factory settings, hold
the OK button down for 3 seconds.
Please note: this will also reset the
timer for cleaning. This may lead to
hygiene issues. As such, cleaning
is recommended after performing a
reset.
To start calibration, hold the 'OK'
button down for 3 seconds.
The calibration routine will then
start automatically and you can
reset the dispensing volume
(see p. 51)
45