Parts Of The Device; Commissioning; Switching On/Off; Settings - Festool OF 2200 EB Notice D'utilisation

English
5

Parts of the device

[1-1]
Adjusting wheel fine adjuster
[1-2] Fine adjuster scale
[1-3]
Height adjustment rotary knob
[1-4] Depth stop scale
[1-5] Depth stop with indicator
[1-6] Depth stop clamp lever
[1-7] Eccentric for coupling the depth stop
and the stepped stop
[1-8] Stepped stop
[1-9] Base runner replacement operating
lever
[1-10] Spindle stop
[1-11] Speed adjusting wheel
[2-1] On/off switch locking button
[2-2] On/off switch
[2-3]
Protective guard locking lever
[2-4] Handles
[2-5]
Extractor stub
The illustrations specified are located at the be­
ginning and end of the operating instructions.
Accessories shown or described are not always
included in the scope of delivery.
6

Commissioning

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
6.1

Switching on/off

The switch [2-2] is an on/off switch (press = ON,
release = OFF).
The on/off switch with the locking button [2-1]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
18
7

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-11] (see "Technical data").
This enables you to optimise the cutting speed
to suit the respective material.
Material Cutter diameter (mm)
10–30 30–50
Adjusting wheel setting
Hardwood 6–4
Soft wood 6–5
Coated 6–5
chipboard
Plastic 6–4
Alumini­ 3–1
um
Plaster­ 2–1
board
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected when the on/off
switch is pressed. In this case, the power tool
must be switched off and then switched back on
again.
Due to the built-in restart protection, the power
tool cannot be switched on and off via an exter­
nal switch module.
Brake
The OF 2200 EB has an electronic brake which
brings the spindle with tool to a standstill within
approx. 2 seconds of the tool being switched off.
Recom­
mended
50–89
cutting ma­
terial
5–3 3–1 HW (HSS)
6–4 5–3 HSS (HW)
6–4 4–2 HW
6–3 3–1 HW
3–1 2–1 HSS (HW)
1 1 HW