Adjustment - arjo Enterprise ENT-ACC02 Mode D'emploi

Installation

Adjustment

Removal
Insert the base of the IV pole into
either of the sockets (A) at the
head end of the bed.
Twist the IV pole while pushing it
down, until it locks into position
and is firmly seated in the socket.
Attach IV equipment to the hooks
as required.
Push up the locking collar (B) and
slide the top section of the IV pole
up or down to the required height.
The pole can be adjusted with
one hand as shown.
ENT-ACC04 only: undo the
clamp screw (C) and adjust the
top section of the pole to the
required height and angle. Re-
tighten the clamp screw firmly.
Remove all equipment from the hooks. Adjust the IV pole to minimum
height and pull the pole vertically out of the socket (A).
2
English
A A
B
C