Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D
TH450
confirms the conclusion of the temperature band programming.
In any case, 10 seconds after the last operation, the unit exits the procedure, considering
the data set until that moment as valid.
N.B. The value you can assign to each temperature band is limited by the values of the
band immediately higher and lower.
If, for example, the T3 band is set to 20 °C and the T1 band is set to 16 °C, the value of
the T2 band can vary between 16.1 °C and 19.9 °C. If T2 is set to 21 °C, T3 is automati-
cally moved to 21.1 °C.
Using the Wildcard program
The device has a WILDCARD program (to be used, for example, during midweek holidays,
vacations etc.), that can be started at any time of the current day and remains active until
24:00, or can be reserved for any of the days of the week.
The factory settings envisage the wildcard program having the same profile as the Sunday
profile
, but it can be customised.
To activate this program for the current day, proceed as follows:
Set AUTOMATIC operating mode.
A
Press button P to confirm the value
of the temperature shown on the
display and move on to the next
temperature level D.
Proceed as described to set all
the temperature bands as desired.
The reappearance of the entire
daily program graph on the display
button A.
Press the
The appearance of the
confirms that the program has
been activated.
icon
Publicité
Table des Matières
