Description Of The Appliance; Charging Process - Kärcher FC 5 Cordless Mode D'emploi

 Keep parts of the body (e.g. hair, fingers) away
from the rotating cleaning rollers.
 Keep your hands protected while cleaning the suc-
tion head- risk of injury from sharp objects (e.g.
splinters).
 Keep connection cable away from heat, sharp edg-
es, oil and moving parts.
ATTENTION
 Only switch on the appliance when the fresh water
tank and waste water tank are fitted.
The appliance must not be used for the intake of

sharp or large objects (e.g. shards, pebbles, toy
parts).
Do not add acetic acids, descaling agents, essen-

tial oils or similar substances to the fresh water
tank. Also ensure that the substances are not
drawn in.
 Only use this appliance on hard floors with water-
proof coatings (e. g. varnished parquet, enamelled
tiles, Linoleum).
 Do not use the appliance for cleaning of carpets or
carpeted floors.
 Do not use the appliance over the floor grilles of
convector heaters. The appliance is not able to
take in the water discharged when used above
grilles.
 In case of longer breaks in operation and after use,
switch off the device at the main switch / device
switch and pull the charger's mains plug.
 Do not operate the appliance at temperatures be-
low 0 °C.
 Protect the unit from rain. Do not store outside.

Description of the Appliance

Illustrations on the picture pages
1 ON/OFF switch
2 Handle
3 Battery indicator
4 Carrying handle
5 Charging socket
6 Waste water tank/separator lid
7 Waste water tank
8 Cover suction head
9 Recessed grip cleaning roller
10 Cleaning rollers
11 Lock suction head
12 Fresh water tank
13 Handle fresh water tank
14 Roller storage
15 Cleaning / park station
16 Filter inlay
17 Charger with charging cable
18 * Detergent
19 ** Detergent
20 ** Detergent
10 ** Cleaning rollers
** FC 5 Cordless
** FC 5 Cordless Premium
14
RM 536 30 ml
RM 534 30 ml
RM 536 500 ml
2x
EN
Assembly
Illustration
 Insert handle into the basic unit as far as it goes un-
til it engages audibly.
The handle must sit snugly into the appliance.
Commissioning
Installing the rollers
Illustration
 Screw the cleaning rollers onto the threaded rod up
to the mechanical stop.
 Pay attention to the colour-codes on the inside of
the roller and roller holder on the appliance (e.g.
blue should match up with blue).
 After the installation, check to ensure that the
cleaning rollers sit snugly.

Charging process

Illustration
 To stabilise, place the appliance into the cleaning
station.
Illustration
 Plug the charging cable of the charger into the
charging socket on the device.
 Plug the mains plug of the charger into a power out-
let.
Illustration
 The LED indicator lights display the battery's cur-
rent charging state.
All 3 LED indicator lights flash from bottom to top

when charging a completely empty battery.
 The lowermost LED lights up continuously when
the battery is 1/3 charged, the two upper LEDs con-
tinue to flash.
 When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED
continues to flash.
 After the battery has been fully charged, the 3 LED
indicator lights will continue to light constantly for
60 minutes. After this time, the LED indicator lights
go out.
Illustration
 Once the battery is charged, pull the mains plug out
of the socket and the charging cable out of the
charging socket.
Fill fresh water reservoir
Illustration
 Remove the fresh water tank from the appliance
using the handle.
Illustration
 Open fuel filler cap.
 Fill the fresh water tank with cold or lukewarm tap
water.
 KÄRCHER detergents/care agents can also be
added to the fresh water tank as required.*
See chapter "Detergents and care products".
 Do not exceed the "MAX" marking when filling.
 Close tank lock.
Illustration
 Insert the fresh water container into the appliance.
 The fresh water tank must sit snugly into the appli-
ance.
ATTENTION
*Follow the recommended dosage instructions on the
detergent/care agent.
– 7