Safety Devices; Description Of The Unit - Kärcher SC 2 Deluxe Mode D'emploi

Safety devices

CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Symbols on the appliance
(according to type of appliance)
Risk of burns, surface of appliance be-
comes hot during operation
Risk of scalding from steam
Read operating instructions
Pressure controller
The pressure controller keeps the pressure in the steam
boiler as constant as possible during operation. The
heating is switched off when the maximum operating
pressure is reached in the steam boiler and is activated
if there is a pressure drop in the steam boiler as a result
of a steam removal.
Safety lock
The safety lock seals the steam boiler from the steam
pressure present. If the pressure regulator is defective
and overpressure occurs in the steam boiler, an pres-
sure relief valve opens in the safety lock and steam
leaks out through the lock.
Prior to restarting the appliance, contact the responsible
KÄRCHER Customer Service.
Safety thermostat
The safety thermostat prevents the device from over-
heating. If the pressure controller fails and the device
overheats, then the safety thermostat switches the de-
vice off.
To reset the safety thermostat, contact the responsible
KÄRCHER Customer Service.

Description of the unit

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Safety lock
1
LED lights
2
Red - mains voltage present and device is heating
up
Green - device is ready for operation
Carrying handle
3
Switch - ON
4
Switch - OFF
5
Park bracket for floor nozzle
6
Cable clips
7
Mains connection cable with mains plug
8
Holder for accessories
9
Steering rollers, rear (2x)
10
Steering rollers, front (2x)
11
Steam gun
12
Unlocking button
13
Selector switch for steam volume (with child lock)
14
Steam lever
15
Steam hose
16
Spotlight nozzle
17
Round brush (small)
18
**Power nozzle
19
**Round brush (large)
20
Manual nozzle
21
Manual nozzle microfibre cover
22
Extension tubes (2 x)
23
Unlocking button
24
Floor nozzle
25
Hook and loop fastener
26
Microfibre floor cloth (1 x)
27
**Microfibre floor cloth (2 x)
28
Accessory bag
29
** optional
Installing accessories
1. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration G
2. Push the open end of the accessory onto the spot-
light nozzle.
Illustration H
3. Connect the extension tubes with the steam gun.
a Push the first extension tube onto the steam gun
so that the unlocking button on the steam gun en-
gages.
The connection pipe is connected.
b Push the second extension tube onto the
first extension tube.
The connection pipes are connected.
Illustration I
4. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration J
The accessory is connected.
Disconnecting accessories
1. Set the selector switch for the steam volume to the
rear.
The steam lever is locked.
2. Push the unlocking button and pull the parts apart.
English
Installation
19